Dynasty Trade CalculatorCheck a trade

Guide

Superflex vs 1QB Dynasty Values

By Dynasty Trade Calculator editorial team · Published 15 November 2026

Superflex and 1QB leagues price quarterbacks on different scales. In Superflex, a second quarterback can start in the flex spot, so almost every team starts two. Quarterbacks gain sharply, and top quarterbacks become hard to trade for. In 1QB, only one quarterback starts, so most quarterbacks slide. Other positions move far less.

Key takeaways

  • Format is the largest single driver of dynasty values. Pick it before you add a player.
  • Quarterbacks carry two separate values on this site, one per format. Other positions carry one.
  • In 1QB, only top rushing quarterbacks hold elite value. The rest slide several rounds.
  • A small Superflex multiplier understates the gap. Native boards price each format on its own.

How do Superflex and 1QB values differ?

The two formats differ in how many quarterbacks start. Superflex lets a team start a second quarterback in the flex spot. 1QB allows one quarterback in the lineup. That one lineup slot changes the whole market. Quarterbacks rise in Superflex and fall in 1QB, while running backs, receivers, and tight ends hold steadier ground in both formats.

Format is the largest single effect on dynasty values. Smash Accept and RotoBaller both stress that quarterbacks gain sharply in Superflex, with top quarterbacks near untouchable, while 1QB leaves only top rushing quarterbacks at elite value and slides the rest several rounds. Both pages were observed on 15 November 2026. No other setting moves one position this far.

Two-quarterback leagues differ from Superflex, and the gap matters. A 2QB league forces two quarterbacks into the lineup, which pushes quarterback value higher still. Only one calculator in the Apex comparison, DynastyTradeCalculator.com (a different domain from this site), offers 2QB as a separate setting. This site covers Superflex and 1QB at launch. A Superflex board is not a safe stand-in for 2QB.

One lineup slot moves the whole market. Format is not a setting detail. It is the price.

Why do quarterbacks gain so much value in Superflex?

Quarterbacks gain value in Superflex because demand doubles while supply stays fixed. Almost every team starts two quarterbacks, so a 12-team league needs 24 starters each week. The pool of startable quarterbacks is small, and not every starter scores well. Scarcity plus demand lifts every startable quarterback, and lifts elite young quarterbacks the most.

KeepTradeCut runs two entirely separate databases for Superflex and 1QB, as its FAQ states. That choice admits the gap is too large for one number with a tweak. RotoBaller, observed on 15 November 2026, notes that quarterbacks sustain value for 10 or more years, most of all in Superflex. A young quarterback in Superflex is the closest thing dynasty has to a long-term asset.

In practice, a Superflex trade for a quarterback costs far more than the same trade in 1QB, since the buyer in 1QB needs only one starter and faces less demand from rivals. Check the quarterback values page for your format before you open talks, and never carry a number across formats. The gap is the point.

What happens to running backs, receivers, and tight ends?

Running backs, receivers, and tight ends move far less between formats than quarterbacks. Their values shift because quarterbacks take more of the total value pool in Superflex, which pushes other positions down in relative terms. The order inside each position stays close to the same. A top running back stays a top running back in both formats.

This site reflects that split in its board rules. Quarterbacks carry two separate values, one for Superflex and one for 1QB. Other positions use one value in both formats on this board. That rule keeps the format gap where it belongs: at quarterback. Check the running back, receiver, and tight end value pages to see each board in full.

Scoring and TE premium move these positions more than format does. Full PPR lifts pass catchers, and TE premium lifts tight ends only. A receiver who gains little from Superflex can gain a lot from full PPR. Read the scoring guide and the TE premium guide before you price a non-quarterback, since the right setting often sits in those two choices, not in the format toggle.

What does the same trade look like in each format?

Take a trade that swaps a mid-tier quarterback for a strong running back. In Superflex, the quarterback side wins, since startable quarterbacks are scarce and every rival wants one. In 1QB, the running back side wins, since the quarterback is easy to replace and the running back fills the thinner position. Same names. Different verdict.

Run this test yourself. Grade the trade on the Superflex calculator, then grade the same names on the 1QB calculator. The totals will move, and the verdict can flip. That flip is not an error. It is the format gap doing its job. If the verdict does not move between formats, the tool is using one board for both, and its numbers deserve doubt.

Small multipliers hide the gap. NextDyne applies a Superflex bump of only 18 percent to quarterbacks. Research observed on 15 November 2026 calls that bump too small against native boards. An 18 percent bump cannot turn a 1QB board into a Superflex board. This site avoids the shortcut: quarterbacks get a separate value per format, so the gap stays honest.

Should you use one board with a multiplier instead?

No. One board with a multiplier is the weakest option for Superflex and 1QB. A multiplier lifts every quarterback by the same rate, but the market does not work that way. Elite young quarterbacks gain far more than aging backups. Separate boards price each quarterback in each format. A multiplier guesses. A board measures.

The research behind this site reaches the same call: launch with native 1QB and Superflex boards, not a single multiplier. KeepTradeCut follows that call with two separate databases. This site follows it with two quarterback values per player. The extra work is the point. Format errors cost more than any other error in dynasty trades, so the board should carry the cost, not the user.

The methodology page states the format rule in full, and the value chart shows the board with the format toggle. If a tool cannot show you two different quarterback values for the two formats, treat its Superflex numbers with care. One number for both formats is a guess with a decimal point.

A multiplier guesses. A board measures. In Superflex, the difference is a starting quarterback.

What mistakes do managers make when they switch formats?

The first mistake is to carry a Superflex value into 1QB, which overpays for quarterbacks. The second is to carry a 1QB value into Superflex, which underpays and kills talks. The third is to forget picks change too: a pick that buys a quarterback in 1QB may not buy one in Superflex. Check the format first, every time.

Picks hold the same number across formats on this site, but their buying power shifts. A first-round pick buys more quarterback value in 1QB, where quarterbacks cost less, than in Superflex, where they cost more. The pick values page lists the ladder, and the fair-trade guide explains how the gap band applies once the format is set. Price the pick against the board in your format.

League size adds a second trap. A 1.12 pick in a 12-team league is not the same slot as a 1.14 pick in a 14-team league, as Smash Accept notes in its methodology, observed 15 November 2026. DynastyProcess admits a related gap: its league-size control renames picks but does not adjust values. This site prices picks for a 12-team league. If your league holds 10 or 14 teams, treat the pick ladder as a guide, not a fixed price.

Get the format wrong and the verdict is fiction, however clean the math looks.

What else should you ask about Superflex and 1QB values?

These answers cover the 2QB split, the 1QB quarterback discount, the smaller moves at other positions, and the format choice for a new league. Each answer follows the same rule as the guide: quarterbacks carry two values, one per format. Grade your trade on the calculator that matches your league.

Is Superflex the same as 2QB?

No. Superflex lets a team start a second quarterback in the flex spot, but does not force it. A 2QB league forces two quarterbacks into the lineup, which pushes quarterback value higher. Only one calculator in the Apex comparison offers 2QB as a separate setting. Treat them as two formats. Never grade a 2QB trade on a Superflex board.

Why do quarterbacks cost less in 1QB leagues?

Only one quarterback starts in 1QB, so demand stays low while supply stays high. Most teams can find a starter without paying a star price. Only top rushing quarterbacks hold elite value in 1QB, and the rest slide several rounds, as Smash Accept and RotoBaller both note. Scarcity sets the price, and quarterbacks are not scarce in 1QB.

Do running backs and receivers change value between formats?

They move far less than quarterbacks. Their order inside each position stays close to the same in both formats. On this site, only quarterbacks carry two format values. Scoring and TE premium move non-quarterbacks more than format does, so check those settings before you price a running back or receiver.

Which format should a new dynasty league pick?

That choice belongs to the league. Superflex raises quarterback value and rewards teams that draft two strong quarterbacks. 1QB keeps quarterback costs low and pushes draft focus toward running backs and receivers. Pick the format that fits how your league wants to play, then grade every trade on that format. Never mix the two.

What should you read next?

Three guides extend the format choice. The TE premium guide shows the next setting that moves tight ends. The scoring guide shows how PPR changes pass catchers. The values guide explains where each number comes from. Set your format first, then read the setting that shapes your next trade.